First print of SmartrapCore
The smartrapcore-3d-printer build is now finally in the phase where there is something visible coming out from the printer. After lots of hardware work, some electrician skills and tuning and turning it is time...
The smartrapcore-3d-printer build is now finally in the phase where there is something visible coming out from the printer. After lots of hardware work, some electrician skills and tuning and turning it is time...
The wheels are now on the robot as the rims were readily waiting at the 3d-printer. Some drilling was required to get the center hole to fit the servo attachment and to get the screws...
As the quality or brand of the kapton tape we have too many rolls of is not too good and whilst the print does stick well on kapton+abs-juice the kapton does not stay on...
Jäsenemme Jarmo on alkanut kokoamaan itse suunnittelemaansa 3D-tulostinta. Runko on tehty kierretangoista ja verstaalla käytössä olevalla 3D-tulostimella tehdyistä kulmapaloista.
The old belts on the mendel90 3d-printer were a bit stiff and that was considered to have an impact on the random skipping behaviour of the printer. As seen in the photo of small...
Update: 2015-04-20. Batteries lasted for about 11 days before the voltage was presumed to be to low as there were gaps in data (around 2.6V). Now it is hooked to a tiny solar panel...
Parista ohjepostauksesta ja Youtube-videosta inspiroiduin testaamaan ABS-muovista 3D-tulostetun kappaleen pintakäsittelyä laittamalla ne samaan tilaan höyrystetyn asetonihöyryn kanssa. ABS-muovi liukenee asetoniin ja höyrystettynä muovikappale imee sitä tasoittaen pinnan.
The service was pretty easy to finalize and z-calibration is not that far off. At the moment it is fixed in the 3d-printing workstation slic3r with “z-offset: -0.08 mm”. The former was -0.17. Might...